[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[plamo:28138] Re: libata installer



尾形です。

今回はもう少し以前のM/Bでテストしてみました。
ASUS TUV4X Celeron900MHz
Apollo Pro133T Chipset

Plamo-4.21のinstall及びgrubのinstallは問題なく出来ました。

しかし再起動でSuspend2たぶんACPIのところでkernel Panicと
なってしまいました。2度の再起動後起動時から画面が表示され
なくなり、おそらくグラフィックカードか電源かということで1週間
dmesgのログがそのままになっていました。G400からG450の
交換で画面表示は出来るようになりました。Plamo-4.21の起動
kernel Panicはそのままで深追いはしません。

KOJIMA Mitsuhiro wrote:
> 今回公開した libata 採用のカーネルでは,libata 回りはモジュールではなく
> カーネル組み込みになっているので,カーネルレベルでの認識の順番は変更で
> きないでしょう.
>   
そのようですね。isoイメージを-o loopでconfigを見た時組み込み
がわかりました。

以下lspciとdmesgのhead -83
00:00.0 Host bridge: VIA Technologies, Inc.: Unknown device 0605 (rev c4)
00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598 [Apollo MVP3 AGP]
00:04.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super] (rev 40)
00:04.1 IDE interface: VIA Technologies, Inc. VT82C586 IDE [Apollo] (rev 06)
00:04.2 USB Controller: VIA Technologies, Inc. VT82C586B USB (rev 1a)
00:04.3 USB Controller: VIA Technologies, Inc. VT82C586B USB (rev 1a)
00:04.4 Host bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI]
(rev 40)
00:05.0 Multimedia audio controller: C-Media Electronics Inc CM8738 (rev 10)
00:08.0 Ethernet controller: Digital Equipment Corporation DECchip 21140
[FasterNet] (rev 20)
00:0a.0 Ethernet controller: Digital Equipment Corporation DECchip 21140
[FasterNet] (rev 22)
01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G400 AGP
(rev 82)

e reserved
pnp: 00:03: ioport range 0xe800-0xe80f has been reserved
PCI: Bridge: 0000:00:01.0
IO window: disabled.
MEM window: f8800000-f9dfffff
PREFETCH window: f9f00000-fbffffff
PCI: Setting latency timer of device 0000:00:01.0 to 64
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 5, 131072 bytes)
TCP established hash table entries: 131072 (order: 7, 524288 bytes)
TCP bind hash table entries: 65536 (order: 6, 262144 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
checking if image is initramfs... it is
Freeing initrd memory: 13757k freed
Simple Boot Flag value 0x0 read from CMOS RAM was invalid
Simple Boot Flag at 0x3a set to 0x80
audit: initializing netlink socket (disabled)
audit(1179434782.154:1): initialized
Total HugeTLB memory allocated, 0
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
io scheduler noop registered
io scheduler cfq registered (default)
PCI: Disabling Via external APIC routing
vga16fb: initializing
vga16fb: mapped to 0xc00a0000
Console: switching to colour frame buffer device 80x30
fb0: VGA16 VGA frame buffer device
Real Time Clock Driver v1.12ac
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
input: Macintosh mouse button emulation as /class/input/input0
megaraid cmm: 2.20.2.7 (Release Date: Sun Jul 16 00:01:03 EST 2006)
megaraid: 2.20.4.9 (Release Date: Sun Jul 16 12:27:22 EST 2006)
pata_via 0000:00:04.1: version 0.2.1
ata1: PATA max UDMA/100 cmd 0x1F0 ctl 0x3F6 bmdma 0xD800 irq 14
ata2: PATA max UDMA/100 cmd 0x170 ctl 0x376 bmdma 0xD808 irq 15
scsi0 : pata_via
ata1.00: ATA-6, max UDMA/100, 234441648 sectors: LBA
ata1.00: ata1: dev 0 multi count 16
ata1.00: configured for UDMA/100
scsi1 : pata_via
ata2.01: ATAPI, max UDMA/66
ata2.01: configured for UDMA/33
scsi 0:0:0:0: Direct-Access ATA ST3120023A 3.31 PQ: 0 ANSI: 5
SCSI device sda: 234441648 512-byte hdwr sectors (120034 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: write cache: enabled, read cache: enabled, doesn't
support DPO or FUA
SCSI device sda: 234441648 512-byte hdwr sectors (120034 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: write cache: enabled, read cache: enabled, doesn't
support DPO or FUA
sda: sda1 sda2 < sda5 sda6 sda7 sda8 sda9 sda10 sda11 >
sd 0:0:0:0: Attached scsi disk sda
scsi 1:0:1:0: CD-ROM PIONEER DVD-RW DVR-112D 1.06 PQ: 0 ANSI: 5
sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.20
sr 1:0:1:0: Attached scsi CD-ROM sr0
Fusion MPT base driver 3.04.03
Copyright (c) 1999-2007 LSI Logic Corporation
Fusion MPT SPI Host driver 3.04.03
Fusion MPT FC Host driver 3.04.03
PNP: PS/2 Controller [PNP0303:PS2K,PNP0f13:PS2M] at 0x60,0x64 irq 1,12
serio: i8042 KBD port at 0x60,0x64 irq 1
serio: i8042 AUX port at 0x60,0x64 irq 12
mice: PS/2 mouse device common for all mice
input: AT Translated Set 2 keyboard as /class/input/input1
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
Suspend v2.2.9.7
Time: tsc clocksource has been installed.
Suspend2 Checksumming support registered.
Suspend2 Userspace Storage Manager support registered.
Suspend2 Userspace UI support registered.
Suspend2 Compressor support registered.
Suspend2 Encryptor support registered.
Suspend2 Block I/O support registered.
Suspend2 Swap Allocator support registered.
Suspend2 File Allocator support registered.
ACPI: (supports S0 S1 S4 S5)

では。





Follow-Ups
[plamo:28139] Re: libata installer, Takehiko Ogata
References
[plamo:28119] Re: libata installer, Takehiko Ogata
[plamo:28120] Re: libata installer, Takehiko Ogata
[plamo:28122] Re: libata installer, Takehiko Ogata
[plamo:28136] Re: libata installer, KOJIMA Mitsuhiro

[検索ページ] [メール一覧]
Plamo ML 公開システム